Sand Washing Polyacrylamide

- Aug 02, 2019-

The sand and mud flow from the sand washing factory is extremely high in sediment content, which will seriously pollute the river and cause great pollution to the environment. Therefore, the use of Quansen polyacrylamide as flocculants for the useful disposal of the wastewater from the sand washing factory becomes the most important work! Quansen anion polyacrylamide can achieve a very good effect, and its water solubility is good, in the case of using a little amount, you can see the obvious effect.

Application of Quansen PAM in sand washing

Sand washing wasterwater treatment polyacrylamide is a kind of water containing a certain amount of fine clay particles suspended liquid and mud properties depend on its composition, related to the geological conditions, general characteristics is the color of loess mud appearance, uniform gooey, long time still not stratified, density between 1.2-1.46 (density of sand is 1.6), the sediment content from 20% to 30%, the PH in 6-7.

 

The long chain of polyacrylamide molecules enables it to bridge between two particles, and accelerating particle deposition is an excellent flocculant.

Quansen anion polyacrylamide is able to successfully dispose of the waste water of the sand washing plant, and its water solubility is good, and can reach very good results, usually only 0.01~10ppm (0.01~10g/m3) can be used.

Low dosage, fast settlement speed and low cost.